- EATON-VICKERS液压元件，DG4V-3-2A-M-P2-T-...

EATON-VICKERS液压元件，DG4V-3-2A-M-P2-T-7-52
液压管路将加压流体从泵到马达和回流从电动机
灵活或脊。一个电源和一个泵的尺寸可以提供一个马达或许多
一台泵和多台电机可串联或并联连接（见各类型的连接
当泵连接到电机系列内部的过剩压力的情况下是在创建
在每个电机压力必须接回油箱。然而，使并联连接时
电机没有多余的情况下，压力将增加。因此，使用壳体泄油口是没有必要的。
查看应用程序，看看这个可选的壳体泄油口可以连接到你的优势，
马达与泵连接，并联连接到泵多台电动机，以及多个电机
电机与有序壳体泄油口将随安装在年底钢六角插头
...泄油的优势 - 除了用于连接马达提供较低的情况下的压力
使增加了外部壳体泄油管的马达具有正常的情况下，压力为好。
包括：污染控制 - 冲洗马达壳体。冷却器系统 - 排出的油液使马达
延长汽车密封件的寿命 - 通过安装在预设的限制，低压力的情况下
EATON-VICKERS液压元件，DG4V-3-2A-M-P2-T-7-52
The hydrodynamic bearing has infinite life when shaft load
ratings are not exceeded. Hence, the shaft side load capacity
is more than adequate to handle most externally applied
loads (such as belts, chains, etc.), providing the motor to
shaft size is applied within its torque rating.
Allowable side load chart, shaft load location drawing and
load curves (below) are based on the side / radial loads
being applied to shaft at locations A, B, and C, to determine
the shaft side load capacity at locations other than those
shown use the formula (shown below). For more information
about shaft side loads on Char-Lynn motors contact
Use of Teflon Tape Sealant/Lubricant (with
1/2 14 NPTF Port Connectors only).
When using fittings with Teflon tape, be careful
when taping and tightening. Over tightening or
improperly taped fittings can cause damage
Use the following procedures:
?Wrap approx. 1 1/2 Turns of 13 mm [1/2 in.]
wide Teflon Tape around fitting threads ?start
tape 2 threads up from end of fitting.
?Tighten threads to a Maximum of 34 Nm [25
lb-ft]. ?Do Not Tighten Further ?
eak when tightened to maximum
torque, either retape, reseal, or replace fittings.