Technical data
Pressure range, gauge 0 ... 10 bar to 0 ... 1000 bar, other ranges available without additional cost
Standard pressure range bar 25 50 100 250 400 800 1000
Overload bar 40 100 200 500 800 1000 1200
Linearity, pressure hysteresis and
repeatability
% FS < 0,5
Overall accuracy % FS
< = 1,0 (0 ... +80°C)
< = 1,5 (−25 ... +100°C)
< = 2,5 (−40 ... +125°C)
Long-run stability % FS p.a. < 0,2
Media temerature °C −40 ... +150
Operating temerature °C −40 ... +125 (−25 ... +85°C at cable output)
Storage temperature °C −40 ... +125 (−25 ... +85°C at cable output)
Voltage supply
9 ... 36 VDC
14 ... 36 VDC (0−10 V voltage output)
5 V ± 10 % VDC (ratiometric output) allowable ripple @ 50 Hz: 10 %
Output signal 4 ... 20 mA (2-wire-technique), 0/4 ... 20 mA (3-wire-technique), 0 ... 10 V, 0 ... 5 V, 1 ... 6 V,
10 ... 90 % VCC (ratiometric output)
Electrical protection Short circuit protected, signal on GND/VCC and inverse-polarity protection (at non ratiometric output)
Electrical connection
M12-connector, DIN-Bayonet (per DIN 72585); DT04 3-pole, DT04 4-pole
AMP-SuperSeal 1.5; Cable output
other connectors on request
Pressure connection G 1/4, 1/4 NPT, G 1/4 with manometer, 9/16 ... 20 UNF (SAE 4,) 9/16 ... 18 UNF (SAE 6),
other pressure connectors on request
Protection class IP 67 or IP 69k (depends on the electrical connection)
Installation torque up to 35 Nm
EMV
EN 61000-6-2
EN 61000-6-3
E1-accreditation
Shock 500g per IEC 60068-2-27 (Shock mechanical)
Vibration 20g per IEC 60068-2-6
Material with medium contact EN/DIN 1.4548 / FKM
Material housing EN/DIN 1.4301
Material diaphragm EN/DIN 1.4548
Material connector PBT-GF30
Pressure transmitter M01
The M01 is especially designed to be used in off-highway vehicles. The EMC, shock and vibration protection is designed for these machi-nes and the rough environment they operate in.
The M01 is available for pressure ranges from 0 ... 10 bar up to 0 ... 1000 bar. Within the compensated temperature range the accuracy
is 1% overall. The M01 can be used with a medium temperature of up to 150°C (302°F) and the maximum permissible ambient tempe-rature is 125°C (257°F). All parts with medium contact are of stainless steel (1.4548). With the welded thin-film measuring element, the
transmitter has a high media compatibility. An optional damping element can be integrated into the medium access. The housing is also
constructed of stainless steel (1.4301).
The M01 is manufactured according to ISO/TS 16949 and is certified in accordance with E1. The good cost/performance ratio makes this
pressure transmitter ideal for series production in off-highway vehicles and industry. OEM versions are also available.
Pressure transmitter M01