基恩士光纤传感器原理/KEYENCE光纤传感器型号
![](http://item.yiqi.com/pic/ConPic/1/content16-14-40-34-3243.jpg)
接口 由NPN集电极开路或无电压接触信号输入控制 通过RS-232C
电源 24 VDC±10%
消耗电流 Z大240 mA
环境温度 0 至 +50°C (32 至 122°F), 无冻结
Weight about 700 g (without holder)
1. 1.5 ms per second during the self-compensating sequence to avoid temperature fluctuations.
2. Connecting the OP-5148 PNP Output Converter Easily convert the NPN output to a PNP output.
显示速率 20 c/s
控制输入 同步,保持,重设,自动归零,外部设定
控制输出 (2) 容限 可选择8个可编程设定 (每个程序有4个步骤)
相对湿度 35 至 85%, 无凝结
抗振性 10 至 55 Hz, 1.5 mm 双振幅在 X, Y, 及Z方向, 各2个小时
重量 约700 g (不含固定架)
1. 在自我补偿序列期间每秒需要1.5 ms以避免温度波动。
基恩士光纤传感器原理/KEYENCE光纤传感器型号
2. 连接OP-5148 PNP输出转换器可容易地把NPN 输出转换成PNP输出。
输入 阻抗 100 Ω
系统 单端点
输入个数 2
取样速率 2000 c/s
Response time 1 ms (when the average is 1) (1)
The interface is controlled by the NPN open collector or no voltage contact signal input via RS-232C
Power supply 24 VDC ± 10%
信号 5 x NPN (HH, HI, GO, LO, LL) : Z大100 mA (Z大40 V )
反应时间 1 ms ( 当平均数为1时)
延迟时间 60 ms (ON/OFF 可选择的)
模拟电压输出 Voltage ±10 VDC
阻抗 100 Ω
反应时间 1 ms (当平均数为1时) (1)
Current consumption up to 240 mA
Ambient temperature 0 to + 50 ° C (32 to 122 ° F) without freezing
Relative humidity 35 to 85%, no condensation
Vibration resistance 10 to 55 Hz, 1.5 mm double amplitude in the X, Y, and Z direction, each 2 hours
基恩士光纤传感器原理/KEYENCE光纤传感器型号